CS609 today quiz solved by
AOA all dearz….
Here are some quiz solved
these are just of idea so best of luck…..
Quiz Start Time: 06:10 PM
Time Left 88
sec(s)
Question # 1 of 10 ( Start time: 06:10:34 PM ) Total Marks: 1
In case of synchronous communication a timing signal is required to identify the start and end of a bit.
Select correct option:
TRUE
FALSE
Quiz Start Time: 06:10 PM
Time Left 89
sec(s)
Question # 2 of 10 ( Start time: 06:10:59 PM ) Total Marks: 1
Total No. of bytes that can be stored in Keyboard Buffer is____.
Select correct option:
16
32
64
128
Quiz Start Time: 06:10 PM
Time Left 89
sec(s)
Question # 3 of 10 ( Start time: 06:11:29 PM ) Total Marks: 1
BIOS supports __________ UARTS as COM Ports.
Select correct option:
6
4
3
2
Quiz Start Time: 06:10 PM
Time Left 90
sec(s)
Question # 4 of 10 ( Start time: 06:12:02 PM ) Total Marks: 1
DCE is _____________
Select correct option:
Data communication equipment
Dual communication equipment
Data clearing equipment
None of given
Quiz Start Time: 06:10 PM
Time Left 89
sec(s)
Question # 5 of 10 ( Start time: 06:12:25 PM ) Total Marks: 1
In counter register bit no. 3 changes its value between 0 and 1 with in ____clock cycles
Select correct option:
1
2
4
16
Quiz Start Time: 06:10 PM
Time Left 88
sec(s)
Question # 6 of 10 ( Start time: 06:13:50 PM ) Total Marks: 1
____ No. of bytes are used to store the character in the key board buffer.
Select correct option:
1
2
4
8
Quiz Start Time: 06:10 PM
Time Left 89
sec(s)
Question # 7 of 10 ( Start time: 06:14:11 PM ) Total Marks: 1
__________ is used to identify the cause of interrupt.
Select correct option:
Interrupt Enable register
Interrupt ID register
Interrupt Status register
None of the above
Quiz Start Time: 06:10 PM
Time Left 88
sec(s)
Question # 8 of 10 ( Start time: 06:14:35 PM ) Total Marks: 1
if the following function, keep(1, 1000); is called in the TSR program, it means that ________ No. of bytes are reserved in the memory.
Select correct option:
8000
16000
32000
64000
Quiz Start Time: 06:10 PM
Time Left 89
sec(s)
Question # 9 of 10 ( Start time: 06:15:49 PM ) Total Marks: 1
In _____________ each byte is needed to be encapsulated in start and end.
Select correct option:
Synchronous Communication
Asynchronous Communication
Both of Synchronous & Asynchronous Communication
None of give
Quiz Start Time: 06:10 PM
Time Left 89
sec(s)
Question # 10 of 10 ( Start time: 06:16:23 PM ) Total Marks: 1
The ______ service # is not used in any interrupt.
Select correct option:
01
02
03
FF
Quiz Start Time: 06:18 PM
Time Left 85
sec(s)
Question # 3 of 10 ( Start time: 06:19:03 PM ) Total Marks: 1
In case of synchronous communication a timing signal is required to identify the start and end of a bit.
Select correct option:
TRUE
FALSE
Quiz Start Time: 06:18 PM
Time Left 87
sec(s)
Question # 4 of 10 ( Start time: 06:19:16 PM ) Total Marks: 1
If we want to send printing on the printer then we have to perform following steps.
Select correct option:
Initialize printer
Read Status
Check Error
All of the given
Quiz Start Time: 06:18 PM
Time Left 85
sec(s)
Question # 7 of 10 ( Start time: 06:20:29 PM ) Total Marks: 1
DTE is ____________
Select correct option:
Data terminal equipment
Data transmitting equipment
Dual terminal equipment
None given
Quiz Start Time: 06:22 PM
Time Left 85
sec(s)
Question # 2 of 10 ( Start time: 06:22:38 PM ) Total Marks: 1
There are two types of communication Synchronous and Anti Synchronous.
Select correct option:
TRUE
FALSE
Quiz Start Time: 06:22 PM
Time Left 86
sec(s)
Question # 3 of 10 ( Start time: 06:22:49 PM ) Total Marks: 1
__________ is used to identify the cause of interrupt.
Select correct option:
Interrupt Enable register
Interrupt ID register
Interrupt Status register
None of the above
Quiz Start Time: 06:22 PM
Time Left 87
sec(s)
Question # 5 of 10 ( Start time: 06:23:11 PM ) Total Marks: 1
DCE is _____________
Select correct option:
Data communication equipment
Dual communication equipment
Data clearing equipment
None of given
Quiz Start Time: 06:22 PM
Time Left 84
sec(s)
Question # 8 of 10 ( Start time: 08:41:56 PM ) Total Marks: 1
Total No. of bytes that can be stored in Keyboard Buffer is____.
Select correct option:
16
32
64
128
Quiz Start Time: 06:22 PM
Time Left 86
sec(s)
Question # 10 of 10 ( Start time: 08:42:17 PM ) Total Marks: 1
DSR stands for __________
Select correct option:
Data set ready
Data service ready
Data stock ready
None of the above
Quiz Start Time: 08:43 PM
Time Left 88
sec(s)
Question # 1 of 10 ( Start time: 08:43:11 PM ) Total Marks: 1
If printer is _____ then printer sends back the ACK signal to the printer interface
Select correct option:
idle
busy
Out of paper
None of the given
DSR STANDS FOR
Data set ready
Data service ready
Data stock ready
None of the above
At IRQ 7 Interrupt # ___ is used.
Select correct option:
0x0A
0x0B
0x0C
x0F
if the following function, keep(1, 1000); is called in the TSR program, it means that ________ No. of bytes are reserved in the memory.
Select correct option:
8000
16000
32000
64000
In case of synchronous communication a timing signal is required to identify the start and end of a bit.
tRUE
FALSE
There are two types of communication Synchronous and Anti Synchronous.
Select correct option:
TRUE
FALSE
The memory addresses of COM ports remain same for all computers.
Select correct option:
TRUE
FALSE
BIOS supports __________ UARTS as COM Ports.
Select correct option:
6
4
3
2
In counter register bit no. 3 changes its value between 0 and 1 with in ____clock cycles
Select correct option:
1
2
4
16
In keyboard status byte bit no. 2 and 3 are used for ctrl and alt keys respectively. which of the following condition is used to check that Ctrl + Alt keys are pressed. Where: unsigned char far * scr = (unsigned char far *)(0x00400017);
Select correct option:
if (((*scr)&12)==12)
if (((*scr)&8)==8)
if (((*scr)&4)==4)
if (((*scr)&2)==2)
is used to identify the cause of interrupt.
Select correct option:
Interrupt Enable register
Interrupt ID register
Interrupt Status register
None of the above
Quiz 2:-
DTE is ____________
Select correct option:
Data terminal equipment
Data transmitting equipment
Dual terminal equipment
None given
If printer is _____ then printer sends back the ACK signal to the printer interface
Select correct option:
idle
busy
Out of paper
None of the given
BIOS supports __________ UARTS as COM Ports.
Select correct option:
6
4
3
2
case of synchronous communication a timing signal is required to identify the start and end of a bit.
Select correct option:
TRUE
FALSE
If we want to send printing on the printer then we have to perform following steps.
Select correct option:
Initialize printer
Read Status
Check Error
All of the given
The memory addresses of COM ports remain same for all computers.
Select correct option:
TRUE
FALSE
There are two types of communication Synchronous and Anti Synchronous.
Select correct option:
TRUE
FALSE
The baud rate is set in accordance with the divisor value loaded within the UART internal registers base +0 and base +1.
Select correct option:
TRUE
FALSE
Total No. of bytes that can be stored in Keyboard Buffer is____.
Select correct option:
16
32
64
128
counter register bit no. 3 changes its value between 0 and 1 with in ____clock cycles
Select correct option:
1
2
4
16
Quiz no 3:-
The ______ service # is not used in any interrupt.
Select correct option:
01
02
03
FF ( not sure )
In _____________ each byte is needed to be encapsulated in start and end.
Select correct option:
Synchronous Communication
Asynchronous Communication
Both of Synchronous & Asynchronous Communication
DCE is _____________
Select correct option:
Data communication equipment
Dual communication equipment
Data clearing equipment
None of given
__________ is used to identify the cause of interrupt.
Select correct option:
Interrupt Enable register
Interrupt ID register
Interrupt Status register
None of the above
____ No. of bytes are used to store the character in the key board buffer.
Select correct option:
1
2
4
8
No comments:
Post a Comment